#---------------------------------------------------------------------------- # Setup the project cmake_minimum_required(VERSION 2.6 FATAL_ERROR) project(clGeometry) #---------------------------------------------------------------------------- # Find Geant4 package, activating all available UI and Vis drivers by default # You can set WITH_GEANT4_UIVIS to OFF via the command line or ccmake/cmake-gui # to build a batch mode only executable # option(WITH_GEANT4_UIVIS "Build example with Geant4 UI and Vis drivers" ON) if(WITH_GEANT4_UIVIS) find_package(Geant4 REQUIRED g3tog4 ui_all vis_all) else() find_package(Geant4 REQUIRED g3tog4) endif() #---------------------------------------------------------------------------- # Setup Geant4 include directories and compile definitions # include(${Geant4_USE_FILE}) #---------------------------------------------------------------------------- # Locate sources and headers for this project # include_directories(${PROJECT_SOURCE_DIR}/include ${PROJECT_SOURCE_DIR}/common/include ${Geant4_INCLUDE_DIR}) file(GLOB sources ${PROJECT_SOURCE_DIR}/src/*.cc) file(GLOB headers ${PROJECT_SOURCE_DIR}/include/*.hh) #---------------------------------------------------------------------------- # Add common subdirectory # set (common_prefix clGeometry_) add_subdirectory(common) #---------------------------------------------------------------------------- # Add the executable, and link it to the Geant4 libraries # add_executable(clGeometry clGeometry.cc ${sources} ${headers}) target_link_libraries(clGeometry ${common_prefix}common ${Geant4_LIBRARIES} G3toG4) #---------------------------------------------------------------------------- # Copy all scripts to the build directory, i.e. the directory in which we # build clGeometry. This is so that we can run the executable directly because it # relies on these scripts being in the current working directory. # set(clGeometry_SCRIPTS clGeometry.in clGeometry.out init.mac init_vis.mac vis.mac ) foreach(_script ${clGeometry_SCRIPTS}) configure_file( ${PROJECT_SOURCE_DIR}/${_script} ${PROJECT_BINARY_DIR}/${_script} COPYONLY ) endforeach() #---------------------------------------------------------------------------- # Copy data # file(GLOB clGeometry_DATA RELATIVE ${PROJECT_SOURCE_DIR} ${PROJECT_SOURCE_DIR}/data/*.dat) foreach(_data_file ${clGeometry_DATA}) configure_file( ${PROJECT_SOURCE_DIR}/${_data_file} ${PROJECT_BINARY_DIR}/${_data_file} COPYONLY ) endforeach() #---------------------------------------------------------------------------- # Install the executable to 'bin' directory under CMAKE_INSTALL_PREFIX # install(TARGETS clGeometry DESTINATION bin)